Rear beam lowered

[PugRory]

How much should I go down at the back if I'm dropping the front 40mm?
How many nicks would anyone recommend?

[welshpug]

Do it properly.

[Eeyore]

Dont use the nicks method. Its not the right way and you dont get the same amount of adjustment.

[Frosty]

To be honest some time the torsion bars don't aways come out so it has to be done the notch method but I don't see how people say there is a 'right' or a 'wrong' way. Just with the notch method you don't have as much adjustment. What ever way you do it you will get what your aiming for which is a lower rear axle

I would say though if you got 40mm springs fit them and see how it looks.

[Alex4193]

I failed on both the notch method and also removing the torsion bars! Have applied heat. Have soaked in penetrating fluid for almost a month. Had damn torsion bar lol.

[bashbarnard]

Sometimes they dont come out at akl. I had one like this on a previous 306. Ended up replacing axle. Then just out or curiosity it took me getting the old one pink with acetalyne and a sledge hammer to.get out and both trailing arm bearing were buggerd