TD04 Outlet Size

[c.gerrard]

Just trying to sort parts for FMIC and struggling to find out the size of the outlet.

I would measure mine, but the pipe I've got on is a right pain the ass

So, if anyone knows it off the top of their head or has one lying around they could quickly measure, that would be great

[Tom]

2" silicon pipe with 54-62mm t bolt style clamps, stronger than jubilees but cheap aswell. Heres what i done:



2" upto 2.25" 90 off the turbo then two 2.25" 90's to get it point over the engine, obviously that might not work on a 306 and you may have to go round the back of the block.

Edit: Also make sure the pipe and the turbo are parallel when you put the pipe on otherwise it wont sit right and it'll leak and be a bitch to do up. You can clock the turbo in situ if you dont have the locating lug in on the cartridge going into the compressor housing. I just used a bar and a hammer and tapped the comp housing round a bit so the pipe sat on it nice (darrenjlobb trick that is)

[ginge191]

If only i saw this a few hours ago, could have measure at the scrappy; theres one sitting open on a scooby

[c.gerrard]

Thank you sigma friend

I'll be routing my COMPLETELY different to that, cheers for the input anyway