Not long owned my 306 1.9D turbo and I've managed to scrape a small art of the side of it on my gate post.. Damage isn't massive but it is big enough for me to wanna get rid of it.
However having trouble finding the right paint code as haven't had the log book sent through yet, I think it's M0GQ - Nile blue is there anyway I can find out if I type on my reg number on google or something ? It's an R reg if that helps..
(03-02-2013, 10:59 PM)Coopesh56 Wrote: Evening all,
Not long owned my 306 1.9D turbo and I've managed to scrape a small art of the side of it on my gate post.. Damage isn't massive but it is big enough for me to wanna get rid of it.
However having trouble finding the right paint code as haven't had the log book sent through yet, I think it's M0GQ - Nile blue is there anyway I can find out if I type on my reg number on google or something ? It's an R reg if that helps..
Ah damn if only I'd known this a couple of hours ago, just gone back to base and the cars at home, was hoping to order some in the week ready for Saturday! Cheers though mate!
(03-02-2013, 11:24 PM)Coopesh56 Wrote: Ah damn if only I'd known this a couple of hours ago, just gone back to base and the cars at home, was hoping to order some in the week ready for Saturday! Cheers though mate!
pop into halfords, they will make you a can up,
takes them 15mins,
Hmm not sure if I've got the ability to spray it... Was thinking of buying one of those small pots of tip up paint, anyone know if these produce good results ?
(05-02-2013, 03:14 PM)Coopesh56 Wrote: Rang halfords and they said they could make a pot up no problem, even though they don't stock it. So cheers for the tip lozz
Just hope they can offer some advice as to whether should spray it or use a touch up pen!
05-02-2013, 08:55 PM (This post was last modified: 05-02-2013, 09:21 PM by Coopesh56.)
got a pic.. just not sure how to upload it, wouldn't let me from my iphone unless i took it there and then and it's saved into my phone mate
However, on the laptop now and think ive figure it out...
Aha! yes, thats the beauty... as mentioned above, any ideas on damage limitation/ repair welcomed!!
Yeah there's a modelling shop near me so was thinking of buying one fro their as they sell some really fine ones, you reckon it would be worth tea cutting the f*ck out of it first to try and bring it out as much as possible?
Could do it in my garage with a rattle can just concerned about getting an even finish as never used one for anything like this before... Think there's more room for error with a touch up set- plus I've used one before for the stone chips on my motorbike...