Search Results
|
Post |
Author |
Forum |
Replies |
Views |
Posted
[asc]
|
|
|
Thread: Blower Motor noise
Post: RE: Blower Motor noise
Did you fix the problem in the end? |
|
rich_n_stace2014 |
DW10 HDi section
|
3 |
994 |
01-05-2016, 08:37 PM |
|
|
Thread: Update: blower motor issue full fan speed all the time
Post: RE: Update: blower motor issue full fan speed all ...
I'm still stuck on this if anything me is able to help pls! |
|
rich_n_stace2014 |
Electrics
|
5 |
1,602 |
01-05-2016, 08:24 PM |
|
|
Thread: Update: blower motor issue full fan speed all the time
Post: RE: Update: blower motor issue full fan speed all ...
I've tested the control wire and voltages are incrementing fine.
Do you know the part number for blower transistors? Some say it's MJ11015 and other forums MJ11016
Don't want to fit the wrong o... |
|
rich_n_stace2014 |
Electrics
|
5 |
1,602 |
11-06-2015, 11:58 PM |
|
|
Thread: Need help with wheel alignment
Post: RE: Need help with wheel alignment
Update:
Tracking was done and handles like a dream :)
The drivers window reg is very temperamental so swapped out for another, one of the cables popped put causing the cable to churn up in the m... |
|
rich_n_stace2014 |
Suspension, Transmission, Handling & Braking
|
23 |
4,780 |
03-06-2015, 10:17 AM |
|
|
Thread: Update: blower motor issue full fan speed all the time
Post: RE: Update: blower motor issue full fan speed all ...
Relay checks out fine, swapped it with another green one (power windows?) |
|
rich_n_stace2014 |
Electrics
|
5 |
1,602 |
03-06-2015, 08:16 AM |
|
|
Thread: Update: blower motor issue full fan speed all the time
Post: RE: Update: blower motor issue full fan speed all ...
Not sure mate, worth a look thanks
The symptoms point to a faulty blower resistor but can't be unless somehow the car is killing the resistors?
[hr]
Been looking for info on how the phase 3 blower wo... |
|
rich_n_stace2014 |
Electrics
|
5 |
1,602 |
02-06-2015, 08:57 PM |
|
|
Thread: Update: blower motor issue full fan speed all the time
Post: Update: blower motor issue full fan speed all the ...
I had been speaking to Tom on here recently with regard to a blower motor that won't adjust when dial is turned and this is just a quick update
Disconnected temperature sensor behind map light sti... |
|
rich_n_stace2014 |
Electrics
|
5 |
1,602 |
02-06-2015, 07:49 PM |
|
|
Thread: Need help with wheel alignment
Post: RE: Need help with wheel alignment
Are there any pin outs for the switch connector blocks online? Hoping I can give motor a quick burst from 12v supply to test if it's that or wiring problem. I know the loom connectors take a beating o... |
|
rich_n_stace2014 |
Suspension, Transmission, Handling & Braking
|
23 |
4,780 |
02-03-2015, 02:32 PM |
|
|
Thread: Need help with wheel alignment
Post: RE: Need help with wheel alignment
Ah I see. It's the auto up that I need. Current part is 11529
I took old one apart today and cleaned then put it together. Mirrors and passenger window now work but still no drivers window. Can hea... |
|
rich_n_stace2014 |
Suspension, Transmission, Handling & Braking
|
23 |
4,780 |
01-03-2015, 01:00 AM |
|
|
Thread: Need help with wheel alignment
Post: RE: Need help with wheel alignment
Cheers will do, they get their tracking jig back Monday so car won't be driven until then.
While I've got your attention, do you know if all phase 3 drivers window switches are compatible? |
|
rich_n_stace2014 |
Suspension, Transmission, Handling & Braking
|
23 |
4,780 |
28-02-2015, 05:07 PM |
|
|
Thread: Need help with wheel alignment
Post: RE: Need help with wheel alignment
Right, I've set them both the same and it's now drivable although pulling left slightly |
|
rich_n_stace2014 |
Suspension, Transmission, Handling & Braking
|
23 |
4,780 |
28-02-2015, 03:40 PM |
|
|
Thread: Need help with wheel alignment
Post: RE: Need help with wheel alignment
I've done both sides, n/s I did last week and was driving fine,
It's only since replacing O/S TRE that it's driving horribly. I did notice the old TRE was slightly bent but the rod seems straight
... |
|
rich_n_stace2014 |
Suspension, Transmission, Handling & Braking
|
23 |
4,780 |
28-02-2015, 02:37 PM |
|
|
Thread: Need help with wheel alignment
Post: RE: Need help with wheel alignment
Was hoping one of you guys had recently done the TRE's and had a note on amount of thread left or turns. Must be pretty similar throughout the 306 range to make it stock unless there's excessive wear ... |
|
rich_n_stace2014 |
Suspension, Transmission, Handling & Braking
|
23 |
4,780 |
28-02-2015, 02:14 PM |
|
|
Thread: Need help with wheel alignment
Post: RE: Need help with wheel alignment
HDi--Power Wrote: (28-02-2015, 01:07 AM)
--
Just get the thing tracked. How cheap can you be?
--
It's not a case of being cheap, the car is not safe to drive until I've sorted it Feels as though i... |
|
rich_n_stace2014 |
Suspension, Transmission, Handling & Braking
|
23 |
4,780 |
28-02-2015, 12:10 PM |
|
|
Thread: Need help with wheel alignment
Post: RE: Need help with wheel alignment
Ok, I've got an idea of the string method cheers
How much thread should be showing or how many turns roughly on the 306's? Want to get the steering fairly central before fine tuning with string meth... |
|
rich_n_stace2014 |
Suspension, Transmission, Handling & Braking
|
23 |
4,780 |
28-02-2015, 12:03 AM |
|
|
Thread: Problems, please help
Post: RE: Problems, please help
Just a very delayed update.... Sorry
Replaced ignition barrel so sll good on that front :)
Replaced blower fan and it's very loud as if it's catching and also constantly on no matter which posit... |
|
rich_n_stace2014 |
Interior, Exterior, ICE
|
1 |
877 |
27-02-2015, 11:28 PM |
|
|
Thread: Need help with wheel alignment
Post: Need help with wheel alignment
Hi guys,
I've just fitted 2 new drop link bars and track rod ends.
First track rod End I'm convinced is in exactly the same position as the original, the drivers side I think I've done wrong.
Dri... |
|
rich_n_stace2014 |
Suspension, Transmission, Handling & Braking
|
23 |
4,780 |
27-02-2015, 11:10 PM |
|
|
Thread: Problems, please help
Post: Problems, please help
hi guys,
Purchased another petrol 306 recently and have a few problems.
1) Ignition doesn't spring at all and having trouble getting wipers etc to work first time without turning back slightly.... |
|
rich_n_stace2014 |
Interior, Exterior, ICE
|
1 |
877 |
07-11-2013, 02:41 AM |