Heater Matrix Pipe Confusion - Printable Version +- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum) +-- Forum: Engines (https://www.306oc.co.uk/forum/forumdisplay.php?fid=16) +--- Forum: XUD Section (https://www.306oc.co.uk/forum/forumdisplay.php?fid=11) +--- Thread: Heater Matrix Pipe Confusion (/showthread.php?tid=8677)

Heater Matrix Pipe Confusion - 306Puggy - 07-12-2012 Right, what's the deal here? The heater matrix pipes that I bought have the correct fitting but the pipes at the other end are metal which is wrong because the cylinder head has metal pipes coming out of it which obviously need rubber hose to go onto them. Luckily I have plenty of spare chopped up hose but is there a way to fit this version properly? RE: Heater Matrix Pipe Confusion - ozonehostile - 07-12-2012 Is that the full length of the pipe? As I remember it the metal section goes up behind the dash and through the bulkhead where two it joins to rubber hoses and into the head from there. The picture would appear to be all the hoses for inside the car Heater Matrix Pipe Confusion - Jonny b - 07-12-2012 No that's right them pipes run along the bulkhead, then there should be 2 rubber hoses to go on the end of that to the block RE: Heater Matrix Pipe Confusion - KrisB - 07-12-2012 I have a pair of these in full rubber/length. £25 posted. What cars this for? Dturbo or gti? Those pipes you have look like gti. RE: Heater Matrix Pipe Confusion - cwspellowe - 07-12-2012 Err nope Jonny, they're gti pipes. DT ones go in different directions, one towards the N/S and one towards the O/S. Those pipes both go to the thermostat housing on the N/S of the gti block. RE: Heater Matrix Pipe Confusion - KrisB - 07-12-2012 Effort, thought that was the case. Heater Matrix Pipe Confusion - Jonny b - 08-12-2012 Well I didn't know what car he had did I ha ha RE: Heater Matrix Pipe Confusion - darrenjlobb - 08-12-2012 There older DT one, the old models had steels across bulkhead (right farce as clogs up space), later ones just had rubber straight to head / distro. RE: Heater Matrix Pipe Confusion - 306Puggy - 08-12-2012 Okay, I'll have to cut the connector off and connect it to the current setup, not a big problem.