+- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum)
+-- Forum: General (https://www.306oc.co.uk/forum/forumdisplay.php?fid=6)
+--- Forum: The Couch (https://www.306oc.co.uk/forum/forumdisplay.php?fid=7)
+--- Thread: Anyone work with a lathe/cnc? (/showthread.php?tid=7052)
Anyone work with a lathe/cnc? - cwspellowe - 16-10-2012
Anyone here got access to a lathe or CNC machine? Need some hub adapters bored out from 63mm centre bore to 65.1mm...
Re: Anyone work with a lathe/cnc? - Alee83 - 16-10-2012
We have CNC and lathes at work! Guys make loads of machined parts, and are good at it, and kinda have to be... Bit far from you though...!
RE: Anyone work with a lathe/cnc? - cwspellowe - 16-10-2012
Hmm how much would we be talking to turn 4x adapters? All I need is 1.05mm radius taken off each
Re: Anyone work with a lathe/cnc? - Alee83 - 16-10-2012
If I have a word, can get it done for nowt! Will just be postage...
RE: Anyone work with a lathe/cnc? - cwspellowe - 16-10-2012
Might be an option then, think you'd be able to press in wheel studs while they're there?
Re: Anyone work with a lathe/cnc? - Alee83 - 16-10-2012
Weld in studs maybe, not too sure on pressing!
RE: Anyone work with a lathe/cnc? - Dum-Dum - 16-10-2012
Get studs made with a M14 thread on one end and pug M12 on the other then just tap the adaptors.
CNC lathe would knock those studs up in minutes.
RE: Anyone work with a lathe/cnc? - cwspellowe - 16-10-2012
not sure about tapping the adapters though, they're billet ally and i'm not convinced on thread strength...
Know what? f*ck it. I'm taking a flap wheel to them. They're lugcentric anyway, just going to keep removing material til they just about fit the hub. Bodgetastic.
Going to pull ford m12x1.5 studs into them too using the ol' nut-and-washer method. For the lolz.
Re: Anyone work with a lathe/cnc? - Alee83 - 16-10-2012
Well, pm me if you want owt doin pal!