+- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum)
+-- Forum: General (https://www.306oc.co.uk/forum/forumdisplay.php?fid=6)
+--- Forum: The Couch (https://www.306oc.co.uk/forum/forumdisplay.php?fid=7)
+--- Thread: MOT failure :-( (/showthread.php?tid=4327)
MOT failure :-( - dec-66 - 20-06-2012
Hi all,
Just a quick question - I hope someone can help me out.
My car has been in for its MOT today and it failed on these 3 things:
- nearside front suspension arm has excessive play in ball joint [2.4.G.2]
- offside front suspension arm has excessive play in ball joint [2.4.G.2]
- rear break load sensing valve seized [3.6.E.3]
what do these three fail involve doing
cheers
RE: MOT failure :-( - samass - 20-06-2012
presumably they are the lower ball joints, in which, remove and replace, and the rear load sensor probably just needs COVERING in wd40 or plus gas or something to get it to free up
RE: MOT failure :-( - Grant - 20-06-2012
Nothing too serious.
As samass says WD40 the load sensor and ball joints £10-15 ea. depending where you go. Fitting them, 20 mins a side if your familiar with doing it...
RE: MOT failure :-( - dec-66 - 20-06-2012
ok cheers where is the rear break load sensing valve located ??
RE: MOT failure :-( - samass - 20-06-2012
on the rear beam, on the drivers side. looks like a plunger with a spring around it with brakes going to it. basically, stick your head under and look for a damper type thing. coat the f*ck out of it lube, and roberts your mothers brother