+- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum)
+-- Forum: 306 Repairs & Mods (https://www.306oc.co.uk/forum/forumdisplay.php?fid=22)
+--- Forum: Suspension, Transmission, Handling & Braking (https://www.306oc.co.uk/forum/forumdisplay.php?fid=19)
+--- Thread: Rear dampers too short? (/showthread.php?tid=36678)
Rear dampers too short? - dt_ - 11-03-2018
Hi guys, just fitting two bilstein dampers (306 gti fitment) to a rear axle (new IM axle set up for zx volcane) and the dampers seem to be about 10mm too short. Maybe my fault, as I took a punt on 306/zx parts being interchangeable, or is there something I'm likely to be doing wrong? I'm certain that if i compress the axle this will then allow the dampers to be fitted, but then it would be the dampers holding the axle's spring tension, stopping it from fully relaxing, and possibly damaging the damper. What do you guys think? Is there a difference in the rear beam setups between the two cars, or is it possible that the axle is set too high?
RE: Rear dampers too short? - welshpug - 11-03-2018
move the arm up, that's normal.
RE: Rear dampers too short? - dt_ - 11-03-2018
Cool, that's a relief, those dampers were quite a bargain. So I can compress the axle, fit the dampers and have the dampers support the axle, or do I need to remove the TBs and adjust the arms?
RE: Rear dampers too short? - Frosty - 12-03-2018
Just need to compress the axle so it makes the gap where the bolts go for the shocks shorter. No need to remove anything.
RE: Rear dampers too short? - dt_ - 12-03-2018
Ok guys, that's good to hear. Thanks a lot for your help!