Bosch Fuel Pump governer shaft (spline)please HELP! - Printable Version +- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum) +-- Forum: Engines (https://www.306oc.co.uk/forum/forumdisplay.php?fid=16) +--- Forum: XUD Section (https://www.306oc.co.uk/forum/forumdisplay.php?fid=11) +--- Thread: Bosch Fuel Pump governer shaft (spline)please HELP! (/showthread.php?tid=34467)

Bosch Fuel Pump governer shaft (spline)please HELP! - Dantheman1312 - 04-07-2016 Hello, This is my first post on this forum! I just swapped my fuel pump over (bosch) beacuse it was leaking veg oil.  I wanted to have the same governer assembly as the last one so I swapped it over I didn't realize that the pump had a spline which had to be lined up ccorrectly...  how can I reset this back to where it should be?  Thanks! ? Bosch Fuel Pump governer shaft (spline)please HELP! - Dantheman1312 - 04-07-2016 This is what I mean the 10mm lock nut is holding it onto the splines Sent from my HTC One M8s using Tapatalk RE: Bosch Fuel Pump governer shaft (spline)please HELP! - Piggy - 05-07-2016 Turn the shaft anticlockwise until it feels like to comes to a natural stop. Fit the throttle arm in the idle position RE: Bosch Fuel Pump governer shaft (spline)please HELP! - Mattcheese31 - 05-07-2016 Loosen the nut, put a screwdriver in the top, set where required and nip the nut back up, does that make sense? RE: Bosch Fuel Pump governer shaft (spline)please HELP! - Dantheman1312 - 05-07-2016 Okay thanks everyone. Got that sorted! Still not running right though.. when I put my foot down there is no power then suddenly at around 2.5k rpm it kicks in. Yes I know it's a turbo and that is normal but it literally has no power until then. Also since I have fitted this pump my boost guage reads 20psi. And the engine seems to run very hot. Any advice? Even in the low revs the turbo spins up and creates a considerable amount of boost I must add that this sounds like it is producing a lot of diesel knock! Sent from my HTC One M8s using Tapatalk RE: Bosch Fuel Pump governer shaft (spline)please HELP! - Piggy - 05-07-2016 Ok...need to retard the pump a little if too much knock. Also sounds like the lda pin is sticking or not dropping. Is it coaling a lot before 2500rpm? RE: Bosch Fuel Pump governer shaft (spline)please HELP! - Dantheman1312 - 05-07-2016 Sorry to sound stupid but I have no idea what coaling means! I thought that about the pump timing. Could the lda pin sticking be caused by oil getting into the diaphragm bit? Sent from my HTC One M8s using Tapatalk RE: Bosch Fuel Pump governer shaft (spline)please HELP! - Piggy - 05-07-2016 Smoking about the exhaust when you accelerate at wide open throttle from low rpm? RE: Bosch Fuel Pump governer shaft (spline)please HELP! - Danny Wideboy - 05-07-2016 Coaling means blowing loads of black smoke out of the back. I wouldn't think oil would cuase a sticky LDA,  unless you run veg oil. Doh! Beat me to it. RE: Bosch Fuel Pump governer shaft (spline)please HELP! - Dantheman1312 - 05-07-2016 Yes just cleaned it all out put back in and problem solved! Thanks for your help! [SMILING FACE WITH OPEN MOUTH] Sent from my HTC One M8s using Tapatalk RE: Bosch Fuel Pump governer shaft (spline)please HELP! - Piggy - 05-07-2016 Haha! Boom!