Ph2/3 front swap to Ph1? - Printable Version +- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum) +-- Forum: 306 Repairs & Mods (https://www.306oc.co.uk/forum/forumdisplay.php?fid=22) +--- Forum: Interior, Exterior, ICE (https://www.306oc.co.uk/forum/forumdisplay.php?fid=12) +--- Thread: Ph2/3 front swap to Ph1? (/showthread.php?tid=32541) |
Ph2/3 front swap to Ph1? - Dazecoop - 17-11-2015 I've done some searching, but can't find much. Apologies as I'm new to 306's, so this might be an obvious answer. Is it possible to swap to a Ph1 front on a Ph2/3 car? I'm looking at (and potentially buying) a Ph2 with Ph3 headlights, but I prefer the Ph1 front. I'd like to swap to Ph1 maybe! Thanks in advance. RE: Ph2/3 front swap to Ph1? - bashbarnard - 17-11-2015 Bumper slam panel wings lights indicators side repeaters hockey sticks And grill RE: Ph2/3 front swap to Ph1? - Dazecoop - 17-11-2015 Nice, thanks! Re: RE: Ph2/3 front swap to Ph1? - Seb_Ryan - 17-11-2015 (17-11-2015, 10:33 AM)bashbarnard Wrote: Bumper slam panel wings lights indicators side repeaters hockey sticks And bonnet? RE: RE: Ph2/3 front swap to Ph1? - Mattcheese31 - 17-11-2015 (17-11-2015, 01:13 PM)Seb_Ryan Wrote:(17-11-2015, 10:33 AM)bashbarnard Wrote: Bumper slam panel wings lights indicators side repeaters hockey sticks good call RE: Ph2/3 front swap to Ph1? - Matt - 17-11-2015 Wiring the lights is a pita afaik RE: Ph2/3 front swap to Ph1? - Redordead89 - 18-11-2015 I would love to see It on a late ph3! Would confuse the cops no end! They'd be like that's not right, wtf, screeeeeeech! Nee naw nee naw nee naw lol. Ok maybe not but it would draw some funny looks for def! RE: Ph2/3 front swap to Ph1? - Mattcheese31 - 18-11-2015 Sam Barker is phase 1ing a phase 3 as we speak RE: Ph2/3 front swap to Ph1? - Dazecoop - 18-11-2015 (17-11-2015, 10:13 PM)Matt Wrote: Wiring the lights is a pita afaikI'm not too worried on wiring. I quite enjoy car wiring (18-11-2015, 12:19 AM)Redordead89 Wrote: I would love to see It on a late ph3! Would confuse the cops no end! They'd be like that's not right, wtf, screeeeeeech! Nee naw nee naw nee naw lol. Ok maybe not but it would draw some funny looks for def!Haha, would they? Surely 99% of cops wouldn't know the difference between Ph1/2/3? Infact, I bet 99% of everyone wouldn't know the difference! (18-11-2015, 09:27 AM)Mattcheese31 Wrote: Sam Barker is phase 1ing a phase 3 as we speakGood shout! I did a search and found his thread. Very cool to see!! http://306oc.co.uk/forum/showthread.php?tid=31030 RE: Ph2/3 front swap to Ph1? - Redordead89 - 18-11-2015 (18-11-2015, 11:20 AM)Dazecoop Wrote:Remember the police used to use 306's mate, if a y plate phase1 rolled by most traffic cops I reckon they would know! Me personally I've only had 16 of them so know them well enough to spot a 306 that's been fkt with a mile away, but yeah most non car people wouldn't know!(17-11-2015, 10:13 PM)Matt Wrote: Wiring the lights is a pita afaikI'm not too worried on wiring. I quite enjoy car wiring @Dum-Dum let's ask the resident officer! Chris what do you think, most cops would notice the difference or not? RE: Ph2/3 front swap to Ph1? - pugtk - 19-11-2015 Are the wings not the same? Also need boot, bumpers and side strips I was actually thinking of doing a complete hdi to phase one conversion, including interior ,bumpers ,boot etc , in a Miami blue Refinement and reliability (stage 3 power) no rods out of the block to worry about with old skool looks (Miami Blue) RE: Ph2/3 front swap to Ph1? - Sambarker - 21-11-2015 Hdi rods aren't indestructible! As for wiring for the lights, if you get a set of ph2/ph3 front lights and smash the connectors out of them, you can make plug and play looms for ph1 headlights The rear lights are a different story. You could get a set of Lexus light looms for a ph2/3 and then get a ph1 wiring loom from a scrapper and make looms up that way. Or like I did just solder ph1 loom onto ph3 wiring. Bit of messing to get ph1 tailgate up and running as ph1 has washer jet on wiper arm as opposed to at the top of the tailgate, and also wiring runs up different sides of the tailgate for the wiper motor. Rest is easy enough. RE: Ph2/3 front swap to Ph1? - Iceman299 - 22-11-2015 I really wanted to do this when i had my ph3 but didnt fancy spending unnecessary money on a 306 lol RE: Ph2/3 front swap to Ph1? - Dazecoop - 23-11-2015 All great info, thanks everyone! "Unnecessary money on a 306" is very true -- haha. But I think I'll go ahead with this! Potentially buying said car tonight, I'll post up photos into a project thread this week! If anyone has any Ph1 parts - please PM me, lol. Especially bonnet/headlights! Thanks! RE: Ph2/3 front swap to Ph1? - Iceman299 - 23-11-2015 (23-11-2015, 10:47 AM)Dazecoop Wrote: All great info, thanks everyone! Tbh if i had kept mine, i would've given in to temptation and gone ahead with it sooner or later lol Good luck with it and keep us posted! |