Gti6 inlet manifold - Printable Version +- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum) +-- Forum: Engines (https://www.306oc.co.uk/forum/forumdisplay.php?fid=16) +--- Forum: XU Petrol Engines (https://www.306oc.co.uk/forum/forumdisplay.php?fid=17) +--- Thread: Gti6 inlet manifold (/showthread.php?tid=30586)

Gti6 inlet manifold - connorp - 25-05-2015 So I've got a 1.8 xs and have been told a gti6 inlet manifold would be good on my car. But how easy/hard is it to fit? What do I need to do to make it work? Should I get someone who knows what they're doing to do it for me? RE: Gti6 inlet manifold - maxzy - 25-05-2015 Installation please see this link : http://306oc.co.uk/forum/showthread.php?tid=161 And also, You and everyone can do it just need only some tools and other related part (New air filter, Clamp, etc) About the result, After I installed to my 406 D8 with a pair of GTI6 Camshafts and Custom made exhaust system Engine respond was better at the mid to High revs and the Top speed increasing about 10 km/h (Depend on Cam timing adjusted) Only the intake manifold installation, From my experience I didn't see the difference Only the suction noise is lounder ! (Maybe the low rev response were worse than stock !) But the result with 1.8 maybe difference from my experience, and also my country weather not so Good (AVG Ambient Temp around 30 Degree celsius and Avg humidity around 70 ! ) RE: Gti6 inlet manifold - Eeyore - 25-05-2015 Ive done this to my 1.8... its alright and sounds great. I had a resonator bung to delete the res box. Basically you need a small cone filter, gasket and the full manifold, throttlebody and all the sensors etc. Gti6 inlet manifold - connorp - 25-05-2015 Where does the resonator bung go? RE: Gti6 inlet manifold - Eeyore - 25-05-2015 On the underside of the manifold where the black box usually is. Gti6 inlet manifold - connorp - 25-05-2015 Nice, cheers man Gti6 inlet manifold - connorp - 24-06-2015 Will the inlet manifold run ok with the gti injectors still on it???? Also I'm guessing this really isn't a good sign? :/ RE: Gti6 inlet manifold - welshpug - 24-06-2015 you need to fit the 1.8 injectors unless you map it. Gti6 inlet manifold - connorp - 24-06-2015 Why is that? RE: Gti6 inlet manifold - Eeyore - 24-06-2015 That goo is fine. Mine had that. I'm fairly sure we have answered that question about gti6 injectors for you in a different thread.... If the ECU gives 50% injector flow... And the flow of 1.8 injectors is 1000 and gti6 is 2000 then 50% is 500and 100p so you are always injecting more and the ECU can't tell how much its putting in... Pretty much. Gti6 inlet manifold - connorp - 25-06-2015 Thanks a lot Will having the fro injectors on cause any damage to anything? I'm going to wait until the weekend to change them over if not RE: Gti6 inlet manifold - welshpug - 25-06-2015 the ecu will know something is not right with the lambda readings, but that'll just confuse the hell out of it as there's only a limited percentage it'll trim it back.