Cylinder head faced 0.33mm removed - Printable Version +- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum) +-- Forum: Engines (https://www.306oc.co.uk/forum/forumdisplay.php?fid=16) +--- Forum: XU Petrol Engines (https://www.306oc.co.uk/forum/forumdisplay.php?fid=17) +--- Thread: Cylinder head faced 0.33mm removed (/showthread.php?tid=30477) |
Cylinder head faced 0.33mm removed - lpr1981 - 15-05-2015 I have just collected the cylinder head from the machine shop!! The pressure test was good, they vacuum tested the valves as I freshly ground them back in to there seats and that was all fine. They skimmed the cylinder head and took 0.33mm off the face, I do not know what the tolerances are for using the started head gasket (which I have already bought). Can somebody advise whether I should be good with a standard head gasket without the valves touching the pistons? The engine is a XU10J4 from a 1994 306 S16 Thanks! RE: Cylinder head faced 0.33mm removed - welshpug - 15-05-2015 they have big valve cutouts so should be ok but there id a repair gasket available. RE: Cylinder head faced 0.33mm removed - lpr1981 - 15-05-2015 Thanks for the reply, I'm in two minds just to give the gasket i've got a try. But just in case I need it in the future where is the best place to get the repair gasket without paying main dealer prices? Thanks RE: Cylinder head faced 0.33mm removed - miles - 16-05-2015 Main dealer gaskets are cheap, the OE Gti6 one is cheaper than any crappy pattern one and they fit correctly which again most pattern ones don't But fit a std gasket, it will be fine, loads of room as the pistons come no where near the top of the block so upping the compression won;t do any harm |