306oc - Peugeot 306 Owners Club & Forum
Sack off your auto adjuster on your clutch cable (BE3 Pull type) - Printable Version

+- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum)
+-- Forum: 306 Repairs & Mods (https://www.306oc.co.uk/forum/forumdisplay.php?fid=22)
+--- Forum: Guides (https://www.306oc.co.uk/forum/forumdisplay.php?fid=9)
+--- Thread: Sack off your auto adjuster on your clutch cable (BE3 Pull type) (/showthread.php?tid=30107)



Sack off your auto adjuster on your clutch cable (BE3 Pull type) - Paul_13 - 16-04-2015

Been doing a bit of research and have made a little discovery.

This will only work on PULL type clutches eg:S16 GTI6 Dturbo . NOT HDI (as this uses a push type clutch)

As i'm converting my HDI to a pull type clutch and GTI6 flywheel this will work perfectly.

Now this is the cable I used (Citroen ZX 16v BE3 Pull type)

[Image: 20150416_132400_zpskjvmqqep.jpg]

There's differences in the bung which goes into the pedal box, also a slight difference in diameter on the plastic part:
Left = ZX cable
Right = 306 Dturbo

[Image: 20150416_131834_zpspt6cfxke.jpg]

Remove the bung on the ZX cable and slice it off 

[Image: 20150416_132215_zpsfnnamj2y.jpg]

Remove the 306 bung by sliding it off, over the plastic clip. No need to cut it (ignore the hack saw blade.

[Image: 20150416_132219_zpsdesc5my7.jpg]

Slide the bung over the end of the ZX clutch cable, now this is where the slight difference in diameter causes a slight issue but i was going wrap a bit of insulation tape around the plastic part so the bung sits central. I cannot see this causing an issue. Or may finding a thin plastic sleeve to take up the gap.

[Image: 20150416_132335_zps6dw1jydv.jpg]

And voila! Finished item. A adjustable pull type cable for a BE3 box .
I'll be fitting in the next few weeks.

[Image: 20150416_132346_zpst6lxzfbk.jpg]


RE: Sack off your auto adjuster on your clutch cable (BE3 Pull type) - welshpug - 16-04-2015

aha, I did wonder if the late ZX ever used the conventional 306 style pedal instead of the clip like the xantia and the 405 used.


RE: Sack off your auto adjuster on your clutch cable (BE3 Pull type) - mr_fish - 16-04-2015

Exact cable setup I used on the 206 XUD. Though I used a Xantia Cable.

Should be ideal for the 306 if your adjuster is playing up.


RE: Sack off your auto adjuster on your clutch cable (BE3 Pull type) - Paul_13 - 16-04-2015

(16-04-2015, 02:04 PM)welshpug Wrote: aha, I did wonder if the late ZX ever used the conventional 306 style pedal instead of the clip like the xantia and the 405 used.

I did originally get the earlier version clutch cable which has the different pedal and the plastic clip which is prone to snappingÂ