306oc - Peugeot 306 Owners Club & Forum
1.9 non turbo engine into an hdi - Printable Version

+- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum)
+-- Forum: Engines (https://www.306oc.co.uk/forum/forumdisplay.php?fid=16)
+--- Forum: XUD Section (https://www.306oc.co.uk/forum/forumdisplay.php?fid=11)
+--- Thread: 1.9 non turbo engine into an hdi (/showthread.php?tid=28089)



1.9 non turbo engine into an hdi - Icywalts - 02-12-2014

I have the 1.9 non turbo engine out of a phase 2.5 I think. I have a rolling shell hdi car with ruined engine. Can the 1.9 block be dropped into the car? Is there an issue with drive shafts or the gearbox or even the loom? I was thinking that if I could combine all my bits I could make a lovely little runner as the engine only has 38 thousand miles on it. I know the idea is usually to take the non turbo out and fit an hdi or xud turbo engine but for the purposes of this is an economy wagon. Any help would be hugely appreciated


RE: 1.9 non turbo engine into an hdi - Seb_Ryan - 02-12-2014

Iirc the n/a derv isnt that economical due to having to drive flat out everywhere lol


RE: 1.9 non turbo engine into an hdi - Jimmy306uk - 02-12-2014

+1 to that above, my nad seems to go through alot of fuel since everywhere I go I put my foot to the metal in order to reach the speed limit haha


RE: 1.9 non turbo engine into an hdi - Icywalts - 02-12-2014

U might be right but as it engine has such low miles and my current daily since I sold my 306 does 25 mpg is I'm lucky I know it will be better than that... plus it means I have a 306 again and I have really missed mine


RE: 1.9 non turbo engine into an hdi - Eeyore - 02-12-2014

just no.... nobody wants that engine.


RE: 1.9 non turbo engine into an hdi - Icywalts - 02-12-2014

But will it fit, this is what I need to know... I know it's not to tour taste but I have everything to build it if it fits hence the question I have had 4 hdi's and I would like without spending too much to get this one running with this engine as it's genuinely low miles and runs so sweetly..


RE: 1.9 non turbo engine into an hdi - John1.4 - 02-12-2014

to be honest, i had a NAD zx, and loved every minute, i wasn't overly concerned about getting everywhere yesterday style, just amazed at quiet on the motorway, 60mph and could only hear the wind going past...lol

then ofc i got my volcane, which having the TD engine, was 1) - more fun, 2) - no less economical, 3) - had turbo noise and shit

TD ftw


RE: 1.9 non turbo engine into an hdi - Icywalts - 02-12-2014

I'm not going to buy another engine as for now it's just to get 306 back in my life... just asked a simple question rather that getting 'td ftw' I'm aware of that and not disputing that but I just wanted to know if any of you knew the issues in fitting the engine it to this shell.


RE: 1.9 non turbo engine into an hdi - vincent1 - 02-12-2014

Too be fair ive just scrapped my 306 nad (very rotten front floors rear wheel arch) i had it for about 5 years it was already on a bosch and yes it may not be the quickest of cars but i was getting roughly 50mpg driving it daily on dual carraige ways and a roads 60mph average. (im in my middle forties so the speed of these isnt really a issue for me ) i was running 100% veg oil it never once let me down.


RE: 1.9 non turbo engine into an hdi - Mattcheese31 - 02-12-2014

Should fit afaik mate yes


RE: 1.9 non turbo engine into an hdi - Icywalts - 02-12-2014

(02-12-2014, 06:05 PM)Mattcheese31 Wrote: Should fit afaik mate yes
Thanks but what does afaik mean?


RE: 1.9 non turbo engine into an hdi - vincent1 - 02-12-2014

as far as i know


RE: 1.9 non turbo engine into an hdi - Icywalts - 02-12-2014

Thanks I couldn't work that out haha