306oc - Peugeot 306 Owners Club & Forum
Installing GTI6 gear stick - Cable too tight not 6th. - Printable Version

+- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum)
+-- Forum: Engines (https://www.306oc.co.uk/forum/forumdisplay.php?fid=16)
+--- Forum: XU Petrol Engines (https://www.306oc.co.uk/forum/forumdisplay.php?fid=17)
+--- Thread: Installing GTI6 gear stick - Cable too tight not 6th. (/showthread.php?tid=28077)

Installing GTI6 gear stick - Cable too tight not 6th. - Eeyore - 01-12-2014

Hi All,

So I had enough of my brake lever for reverse so I fitted a gti6 stick with lift up reverse. I now have a problem...

The reverse cable when clipped into the stick and clipped into the collar is already under tension which means it always goes into reverse not 6th.


Cheers
Sam

RE: Installing GTI6 gear stick - No 5th and only reverse! - Niall - 01-12-2014

Cable is under tension because its not routed correctly
Have you got the stick round the right way? Iirc the bracket on the bottom which connects to the linkage is offset to one side.

RE: Installing GTI6 gear stick - Cable too tight not 6th. - Eeyore - 01-12-2014

yep its on the left of the stick. Its obviously not routed correctly because its not meant to have a gti6 box on the car! D:

RE: Installing GTI6 gear stick - Cable too tight not 6th. - Niall - 01-12-2014

There is a knock out in the bulkhead where it should go through, Drill that out, job done.

RE: Installing GTI6 gear stick - Cable too tight not 6th. - Eeyore - 01-12-2014

I thought I had already done that. It hasnt got any stupidly sharp bends so dont know whats happening.

RE: Installing GTI6 gear stick - Cable too tight not 6th. - Toms306 - 02-12-2014

If its still routed the same as when we fitted the box, that wasn't the right hole iirc!

RE: Installing GTI6 gear stick - Cable too tight not 6th. - welshpug - 02-12-2014

I don't think there needs to be any drilling, just a rubber grommet, was present on an XSi, guess it might not be on a 5 door.

RE: Installing GTI6 gear stick - Cable too tight not 6th. - Eeyore - 02-12-2014

There is definitely no hole on a 5 door. I drilled the only part I could get to under the car.

RE: Installing GTI6 gear stick - Cable too tight not 6th. - Toms306 - 02-12-2014

Would it be a shorter route under the exhaust tunnel, like drill a hole just infront of the gearstick and run it under there? You'd have to heatwrap it though with the exhaust there.

RE: Installing GTI6 gear stick - Cable too tight not 6th. - Eeyore - 02-12-2014

(02-12-2014, 11:48 AM)Toms306 Wrote: Would it be a shorter route under the exhaust tunnel, like drill a hole just infront of the gearstick and run it under there? You'd have to heatwrap it though with the exhaust there.

it would be terrible with the heat and im not sure it would be any shorter. It would definitely be a tighter angle as you come through the tunnel.

RE: Installing GTI6 gear stick - Cable too tight not 6th. - welshpug - 02-12-2014

[Image: 016.jpg]