+- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum)
+-- Forum: 306 Repairs & Mods (https://www.306oc.co.uk/forum/forumdisplay.php?fid=22)
+--- Forum: Interior, Exterior, ICE (https://www.306oc.co.uk/forum/forumdisplay.php?fid=12)
+--- Thread: masks information please (/showthread.php?tid=27791)
masks information please - dr_jekyll - 16-11-2014
Looking at putting crystal lenses onto a ph2 boddy for a different look.
Problem is my ovens too small and dont own a heat gun, is there any other way to seperate the lenses?
RE: masks information please - Toms306 - 16-11-2014
It won't work anyway, the ph2 lights need the frosty bit for the beam pattern.
RE: masks information please - dr_jekyll - 16-11-2014
Seen it done before and will be ran with hid's
RE: masks information please - Connor - 16-11-2014
People also jump off of bridges and cliffs, doesnt mean you should do it
much easier to just fit some ph3 crystals whole
RE: masks information please - Toms306 - 16-11-2014
Get some projectors if you want to run HIDs tbh.
But to answer the original question, you do need heat to separate the glue. Heat gun probably doesn't cost much though?
RE: masks information please - dr_jekyll - 16-11-2014
Im already running crystals, looking for some thing abit different though rather than moretts and angels.
Sounds stupid but would a hairdryer work pmsl. GoNana aplly yellow tint film after
RE: masks information please - Jimbo - 16-11-2014
This makes no sense IMO, PH2 lights with a crystal lense and there not twin optic??
Massive downgrade from ph3s
RE: masks information please - Niall - 16-11-2014
(16-11-2014, 08:33 PM)Jimbo Wrote: This makes no sense IMO, PH2 lights with a crystal lense and there not twin optic??
Massive downgrade from ph3s
This. Being different isn't always better!
RE: masks information please - Slam Wagon - 16-11-2014
Just wrap your crystals. Will look the same and work better.