Removing injector seals help - Printable Version +- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum) +-- Forum: Engines (https://www.306oc.co.uk/forum/forumdisplay.php?fid=16) +--- Forum: XUD Section (https://www.306oc.co.uk/forum/forumdisplay.php?fid=11) +--- Thread: Removing injector seals help (/showthread.php?tid=26919) |
Removing injector seals help - doogle-d turbo - 30-09-2014 Doing the injectors now but how the hell do you get the copper washers and fire seals out of the head!! Help please guys! Removing injector seals help - doogle-d turbo - 30-09-2014 Any tricks people? RE: Removing injector seals help - bashbarnard - 30-09-2014 Pick tool is what i.used Removing injector seals help - doogle-d turbo - 30-09-2014 Cheers mate first one out but can't seem tofind the fire seal now :/ RE: Removing injector seals help - Chris_90 - 30-09-2014 Fire seal is right at the very bottom, just double up on them won't do it any harm Removing injector seals help - doogle-d turbo - 30-09-2014 All in, put a fire seal and washer in each. All cleaned up now and going back together RE: Removing injector seals help - Piggy - 30-09-2014 Dont double up!! You can get them out with some patience. Little pick tool as mentioned. Removing injector seals help - doogle-d turbo - 30-09-2014 O yea there wernt any fire seals in to begin with :/ RE: Removing injector seals help - Piggy - 30-09-2014 There will have been, you sure!? Removing injector seals help - doogle-d turbo - 30-09-2014 Well I wasn't sure but my experienced mechanic guy came round and we just couldn't see them/get them out. Will this cause problems if they were in there to begin with? RE: Removing injector seals help - Chris_90 - 30-09-2014 (30-09-2014, 05:53 PM)Piggy Wrote: Dont double up!! In my old thread here zx said it was ok to double up if you Carnt get them out http://306oc.co.uk/forum/thread-19944-page-2.html Removing injector seals help - doogle-d turbo - 30-09-2014 Well doubled or not turned her over and there was a clunk! Then misfire. Was injector 4 so swapped it with 3 and it's purring now. Very strange. I'm pretty sure there were no fire seals to begin with and it's ran like that on the bosch for 35-40000 miles till it injectors started leaking. Any way all good now! Cheers for tips lads. RE: Removing injector seals help - londondan86 - 30-09-2014 I ended up splitting mine with a screwdriver and bending them out. Removing injector seals help - doogle-d turbo - 01-10-2014 That's what happened in the end. I remember a thread about shakey/knocking engine I did and couldn't get to the bottom of why it vibrated so much. Well since the new seals and washers are in, along with new breather pipe, rocker gasket and a service the engine is so much smoother and nicer To drive. Lack of fire seals may have been why...? |