+- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum)
+-- Forum: Engines (https://www.306oc.co.uk/forum/forumdisplay.php?fid=16)
+--- Forum: XUD Section (https://www.306oc.co.uk/forum/forumdisplay.php?fid=11)
+--- Thread: GT2052V & TD04 Oil Feed Thread (/showthread.php?tid=25355)
GT2052V & TD04 Oil Feed Thread - silverzx - 18-07-2014
Need to know oil feed thread for both turbos.
GT is M10X1?
TD04 is ?
Anyone able to clarify?
Also the thread of the oil feed connector on the back of the block wouldn't hurt.
Thank you!!
RE: GT2052V & TD04 Oil Feed Thread - pugmanxud - 18-07-2014
Td04 is m10x1 and block is m10x1. 5
RE: GT2052V & TD04 Oil Feed Thread - silverzx - 18-07-2014
(18-07-2014, 01:29 PM)pugmanxud Wrote: Td04 is m10x1 and block is m10x1. 5
Sweet will rep you, just need GT fitment now.
RE: GT2052V & TD04 Oil Feed Thread - pugmanxud - 18-07-2014
My gt22 is also m10x1 so quite likely the same
RE: GT2052V & TD04 Oil Feed Thread - silverzx - 18-07-2014
Well according to this thread: http://94.23.248.6/forum/thread-21942-post-401415.html
TD04 is m10x1.5 and GT20 is m12x1.5 ...?
Also this thread says TD04 is M12x1.5: http://www.turbobricks.net/forums/showthread.php?t=293297
How can it be so many damn different sizes...
RE: GT2052V & TD04 Oil Feed Thread - Tom - 18-07-2014
My gt2052v was M10 im sure, i remember buying m12 to begin with an it was too big, have a look at the inlet and see if it looks physically small. Fine thread too 1.25 or 1.0 iirc, check my project thread it should be in there...
RE: GT2052V & TD04 Oil Feed Thread - silverzx - 18-07-2014
Just measured both myself.
GT2052: M10X1
TD04: M10x1.5
Block: TBC
RE: GT2052V & TD04 Oil Feed Thread - Tom - 18-07-2014
The block fitting is M16x1.5 i think, a quick forum search will reveal
