+- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum)
+-- Forum: Engines (https://www.306oc.co.uk/forum/forumdisplay.php?fid=16)
+--- Forum: XU Petrol Engines (https://www.306oc.co.uk/forum/forumdisplay.php?fid=17)
+--- Thread: Wossner ring gap (/showthread.php?tid=17808)
Wossner ring gap - Daniel306 - 04-10-2013
I was never really good at maths so can some one help here
My bore is 87mm, the ring gap for both rings should be .006" x Bore
RE: Wossner ring gap - cully - 04-10-2013
87x.006=0.522mm
Ring end gap should be measured with the ring square in the bore on a fresh hone. Cylinder should be free of any taper.
RE: Wossner ring gap - Daniel306 - 04-10-2013
and thats 0.02"?
RE: Wossner ring gap - cully - 04-10-2013
but is the 006 an inperial measurement if it is you need to convert both into the same units
RE: Wossner ring gap - Daniel306 - 04-10-2013
Yes, 86mm and 0.006 Inch
RE: Wossner ring gap - John1.4 - 05-10-2013
i know the actual gap will change but will the 0.006 be the same for all wossner piston rings? got a set here, but no info to go with them
RE: Wossner ring gap - Daniel306 - 05-10-2013
From there site 0.006 is for forced induction engines
But pug1off says for my engine "If the top rings are chrome shiny ones go 0.48 there and 0.55mm on the iron middle ring."
RE: Wossner ring gap - John1.4 - 06-10-2013
cool thanks
