Bonnet/Boot lid - Printable Version +- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum) +-- Forum: 306 Repairs & Mods (https://www.306oc.co.uk/forum/forumdisplay.php?fid=22) +--- Forum: Interior, Exterior, ICE (https://www.306oc.co.uk/forum/forumdisplay.php?fid=12) +--- Thread: Bonnet/Boot lid (/showthread.php?tid=16966) |
Bonnet/Boot lid - Toast - 02-09-2013 Morning ladies and gentlemen, Just wondering if anyone's had any experience with transportation of large 306 parts in a 306. Found a new bonnet and boot lid on ebay and the guy wants pick up only which is understandable but will they fit. Dont mind doing two trips but would like to know if they fit first. any helps much appreciate Ta Muchley RE: Bonnet/Boot lid - Grant - 02-09-2013 You can fit both in the back of a Vauxhall insignia or Renault Laguna if that's any help? But seriously, of you take the bench and rear of the seats out they shoul just fit. Take plenty of padding!! RE: Bonnet/Boot lid - Piggy - 02-09-2013 suggest.....if he is scrapping the car...swapping them there and then? the boot lid fits fine but bonnet is a bit of a bugger. RE: Bonnet/Boot lid - Toast - 02-09-2013 Will defiantly look at swapping straight over but will take the seats out just in case. Always a bit of a giggle trying to fit large parts into small cars Bonnet/Boot lid - Alee83 - 02-09-2013 I've had a bonnet in my Rallye with all seats in and parcel shelf still in. Loads of room, just be careful. RE: Bonnet/Boot lid - Niall - 02-09-2013 If it comes off a 306, it goes in a 306! RE: Bonnet/Boot lid - WiNgNuTz - 02-09-2013 (02-09-2013, 08:53 PM)Niall Wrote: If it comes off a 306, it goes in a 306! This. /thread RE: Bonnet/Boot lid - kingy - 02-09-2013 (02-09-2013, 08:53 PM)Niall Wrote: If it comes off a 306, it goes in a 306! Lol. Re: RE: Bonnet/Boot lid - kentiiboii - 02-09-2013 (02-09-2013, 08:53 PM)Niall Wrote: If it comes off a 306, it goes in a 306! Qft! RE: Bonnet/Boot lid - Toast - 03-09-2013 Yes it all fitted. well boot lid and a set of wheels which were going for cheap. Change the Bonnet on site boot in the back. Does anyone know the implications of swapping a boot in regards to the VIN number not matching? RE: Bonnet/Boot lid - puglove - 03-09-2013 no there is no issue with thar. there are plugs for the boot lid wiring next to the rear seat belt reel before you cutting the wires RE: Bonnet/Boot lid - Toast - 03-09-2013 Yeah traced back all the wires and disconnected without damaging any wires, only the rear sprayer tube was snapped but ill get a connector for that. RE: Bonnet/Boot lid - Grant - 03-09-2013 (02-09-2013, 08:53 PM)Niall Wrote: If it comes off a 306, it goes in a 306! But he wants to know if both the bonnet and the bootlid will fit in together... |