+- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum)
+-- Forum: Engines (https://www.306oc.co.uk/forum/forumdisplay.php?fid=16)
+--- Forum: XUD Section (https://www.306oc.co.uk/forum/forumdisplay.php?fid=11)
+--- Thread: exhaust Q (/showthread.php?tid=15849)
exhaust Q - padge - 24-07-2013
if you were to make your own exhaust by buying pipe in sections, what angle/lengths would you need? not including the downpipe.
RE: exhaust Q - Piggy - 24-07-2013
I think you would need to layout a std exhaust and measure it all mate.
bit of your time and a pen/paper and tape!
RE: exhaust Q - padge - 24-07-2013
I know dum dum has done it, but he used 3" bore
RE: exhaust Q - Tom - 24-07-2013
Look here.
http://306oc.co.uk/forum/thread-3849-page-4.html
And here.
http://306oc.co.uk/forum/thread-1170-page-13.html
I think Jonny has made a couple now, he would be the best to help :p
RE: exhaust Q - Jonny81191 - 24-07-2013
You need the following (for an estate, assume the same for a sedan?)
2m straight pipe (you only need 95cm IIRC for the main centre section, but it's worth having the spare for the back etc..)
1x 45* bend
2x 60* bends
1 15cm flexi section
1x welded 90* tight radius bend (if you have a tdo4 or similar with a side facing exit)
a backbox of some sort.
Top one is off my estate with a rear exit GT20, the bottom one is off Carl's sigma TD04 XUD
RE: exhaust Q - c.gerrard - 24-07-2013
Thought you were having one made up?
I think all you would need would be two 60 degree bends and we could only get the straight pipe in 2 meter lengths with some left over, so not sure exactly how much you would need.
I'd double check the angles, as I can't remember exactly
RE: exhaust Q - Jonny81191 - 24-07-2013
My list is correct, just checked the part numbers
It is also worth buying a mandrel bent 90* to chop up to make small bends where needed. or if you're not that fussed about flow you can just cut pipes at an angle.
RE: exhaust Q - padge - 24-07-2013
I only want it from the downpipe, as I already have a downpipe made, just need the rest onwards to the back.
RE: exhaust Q - Jonny81191 - 24-07-2013
In that case, 2x60* bends, about 1m pipe, and a box.
RE: exhaust Q - padge - 24-07-2013
don't want a box
so 2m pipe, how much of the 60* bends will I need?
RE: exhaust Q - Jonny81191 - 25-07-2013
Erm, all of them? as in both?
RE: exhaust Q - padge - 25-07-2013
length
RE: exhaust Q - padge - 27-07-2013
just to clarify, standard xud exhaust is 2" right?
RE: exhaust Q - martyn92 - 27-07-2013
Think it goes less than that in places.
How much did that cost you roughly Jonny?