306oc - Peugeot 306 Owners Club & Forum
intercooler gasket - Printable Version

+- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum)
+-- Forum: Engines (https://www.306oc.co.uk/forum/forumdisplay.php?fid=16)
+--- Forum: XUD Section (https://www.306oc.co.uk/forum/forumdisplay.php?fid=11)
+--- Thread: intercooler gasket (/showthread.php?tid=13395)



intercooler gasket - pauldiesel - 30-04-2013

I've got a leaky leak off pipe on one of my injectors and was hoping to change it over, I know I need to take the intercooler off to get to it but will I need a new gasket when putting it back on or will the old one do?Huh


RE: intercooler gasket - n0v0s - 30-04-2013

I put on a new gasket, and must have reused it near 30/40 times. I used a bit of silicon to hold it in place due to expansion. Sealed ok at 35psi+ .. Should be fine if yours is in gd condition. Less than a fiver new.


RE: intercooler gasket - Ruan - 30-04-2013

(30-04-2013, 02:21 PM)n0v0s Wrote: I put on a new gasket, and must have reused it near 30/40 times. I used a bit of silicon to hold it in place due to expansion. Sealed ok at 35psi+ .. Should be fine if yours is in gd condition. Less than a fiver new.

Lolz, this...

The amount of times I've reused D seals and steel inlet gaskets...

Worst case scenario if it falls out and you can't get it back in due to expansion - cut it, take a little chunk out and superglue back together... Works every time for me.


RE: intercooler gasket - Jonny81191 - 30-04-2013

AFAIK you can't get them from Peugeot any more so looks like you'll have to reuse it Big Grin


RE: intercooler gasket - Dicky - 30-04-2013

(30-04-2013, 03:48 PM)Ruan Wrote:
(30-04-2013, 02:21 PM)n0v0s Wrote: I put on a new gasket, and must have reused it near 30/40 times. I used a bit of silicon to hold it in place due to expansion. Sealed ok at 35psi+ .. Should be fine if yours is in gd condition. Less than a fiver new.

Lolz, this...

The amount of times I've reused D seals and steel inlet gaskets...

Worst case scenario if it falls out and you can't get it back in due to expansion - cut it, take a little chunk out and superglue back together... Works every time for me.
I do this..


RE: intercooler gasket - r3k1355 - 30-04-2013

Still sell them on eBay.


RE: intercooler gasket - pauldiesel - 30-04-2013

Cheers everyone, I'll whip it off tomorrow and have a look, not sure what it's gonna look like as the car has over 200 k on the clock, it's probably well knackered


Re: intercooler gasket - aggyj17 - 30-04-2013

I just ordered a couple from peugeot so you can still get them Tongue


RE: intercooler gasket - Jonny81191 - 30-04-2013

(30-04-2013, 05:12 PM)aggyj17 Wrote: I just ordered a couple from peugeot so you can still get them Tongue

Must just be my local place being gay, I'll give them some abuse next time I go in there.