+- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum)
+-- Forum: General (https://www.306oc.co.uk/forum/forumdisplay.php?fid=6)
+--- Forum: The Couch (https://www.306oc.co.uk/forum/forumdisplay.php?fid=7)
+--- Thread: Anyone fit engines? (/showthread.php?tid=11878)
Anyone fit engines? - Joe205 - 13-03-2013
Ok, so I replaced the fuel sender unit and it started. My happiness was short lived when I could still hear a very loud tapping from the engine. Just weighing up my options . I may break it but not many good panels. Does anyone on here fit engines? As my Talent doesn't extend to that, I know it's not rocket science but I just don't have the patience to do so. It's a 306 Hdi estate w reg. if so a price would be great so I could way up my options. Thank you
RE: Anyone fit engines? - Piggy - 13-03-2013
where are you?
sure its engine tap?
RE: Anyone fit engines? - Dicky - 13-03-2013
http://www.krisb.co.uk/
RE: Anyone fit engines? - Dum-Dum - 13-03-2013
^^^ as above
Or it really Isnt terribly hard to do yourself. Heater matrix hoses and drive shafts are the worst bit.
Anyone fit engines? - JamesG - 13-03-2013
Hdi engine is a piece of piddle to change! Grab an engine crane and a handful of tools and an unexpected passer by and you'll have it done in no time.
RE: Anyone fit engines? - Tom - 13-03-2013
Would be alot cheaper for you to just spend a weekend doing it.
Anyone fit engines? - Joe205 - 13-03-2013
Located in Shrewsbury. I ran the engine with hardly any oil reading. I have put a litre and a half in and still so noisy! Sound is worse when you put your head in the driver wheel arch. Just fed up of bloody thing. Car has only done 100000 so pretty low mileage. Just don't want to do it myself or will just put for sale and buy another daily.
Anyone fit engines? - JamesG - 13-03-2013
How far you willing to drive as I have a hdi engine I'm
Currently breaking so we could negotiate something
RE: Anyone fit engines? - daddyfixit - 13-03-2013
drivers side ??? sure its not the crank pulley broken up ---they make an horrendous noise sometimes ??? get a light and check with engine running that the outer rim of the pulley isnt flapping all over the place .
RE: Anyone fit engines? - Piggy - 13-03-2013
defo sounds like crank pulley!
RE: Anyone fit engines? - spike2002 - 13-03-2013
Good to meet you the other day
If its crank pulley I have a solid one if you are interested 
Anyone fit engines? - Joe205 - 13-03-2013
Ok thanks guys. Will try put it in ramps tomorrow and have a look. Is it a expensive job? Yes you too lee
RE: Anyone fit engines? - Oil-burner - 13-03-2013
How much for the solid pulley lee?
RE: Anyone fit engines? - Poodle - 14-03-2013
It isnt an expensive job, if you really cant cope with doing it yourself.