+- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum)
+-- Forum: Engines (https://www.306oc.co.uk/forum/forumdisplay.php?fid=16)
+--- Forum: XUD Section (https://www.306oc.co.uk/forum/forumdisplay.php?fid=11)
+--- Thread: No turnover(gearbox change) (/showthread.php?tid=11141)
No turnover(gearbox change) - pugtk - 20-02-2013
Im just after changing a gearbox in my dw8 berlingo, everything has went fine,started it up a coupe of times,went threw all my gears etc.
I then knocked off the van,topped up my coolant and filled my washer bottle(small usually spillage )
I then went to crank the van over again to bleed the system,the van didnt crank,I previsouly had just left the battery earth sitting loose,so i went to tighten the clamp down, but still nothing
I noticed the my glow plug light would not go on , so i disconnected my battery and reconnected
the speedo jumped up, when i turned ignition on (speedo went back to normal)i would get all my usual lights and the glow plug light would flash on briefly ,then i would not get the glow plug light again
No cranking still, I could take the key out and still have lights on in the dash,
I could disconnect/reconnect the battery and i would have the same symptoms again but then my dash could go completely dead
Ive checked the gearbox earth,fine and the earth at the washer bottle
I have 12v at the starter on the large wire,but when i cross it no sparks,and it doesn't engage
Ive been thinking of reseting the bsi,but don't know the procedure?
ANY IDEAS??
RE: No turnover(gearbox change) - vincent1 - 21-02-2013
try using one jump lead from battery negitive terminal to a earth point on your engine ie lifting eye point my guess leaving the earth wire of you may of burnt through a lot thinner earth wire.
RE: No turnover(gearbox change) - pugtk - 21-02-2013
turned out to be the gearbox earth,cleaned the new box up with a wire brush