SRowells Sinclair C5

[Eeyore]

So i took the control box out and found that i had broken the solder on the X5 contact. the control board isnt designed to be removed from the box as its plastic welded in but luckily only about 6 spots so easily cut through them with a knife to get it out. Still not working!





took the pod off which simply clips on and has a few screws. All contacts and pins look good here.




Put it back together and motor engaged but then stopped. then went into a high motor load alarm flashing the pod lights and sounding the alarm. Not sure whats going on but because im getting 12v to the motor when the button is pressed the next thing to check is motor brushes which may be jammed. Its a motor out job to check and hopefully i wont have to pull it apart.



new stickers also went on as it started to rain.