Search Results
|
Post |
Author |
Forum |
Replies |
Views |
Posted
[asc]
|
|
|
Thread: just tuned the lucas pump-how many turns has everyone done?
Post: RE: just tuned the lucas pump-how many turns has e...
Mitch Wrote: (29-07-2013, 06:30 PM)
--
In my experience they all seem to be different, mine was turned all the way to the stop, as for the compensator id suggest turning it all the way in then 1 or t... |
|
306 d turbo |
XUD Section
|
9 |
4,895 |
29-07-2013, 06:46 PM |
|
|
Thread: just tuned the lucas pump-how many turns has everyone done?
Post: just tuned the lucas pump-how many turns has every...
Alright,just.turned the max fuel screw by 90.degrees....bit of.smoke boosting.at.17 psi
How.much has every1 turned there.max fuel up?
What shall i do with the boost compensator in terms of.which... |
|
306 d turbo |
XUD Section
|
9 |
4,895 |
29-07-2013, 06:17 PM |
|
|
Thread: Alloys-Nimrods with spacers and bolts
Post: Alloys-Nimrods with spacers and bolts
Up for sale are my 206 GTI Nimrods with 205/45/16 Tyres all with 4-6mm tread.Very clean with the odd blemish here and there as expected for age.
Come with H and R 10mm Hub centric spacers which cos... |
|
306 d turbo |
Parts
|
0 |
1,108 |
28-05-2013, 05:36 PM |
|
|
Thread: Primer bulb sucked in and wont return?!
Post: Primer bulb sucked in and wont return?!
Driving along,lost power.
will start after alot of turning over,then when moving off will pull ok for 5 seconds then just shut down.
Primer bulb is fully sucked in!Wont return to normal position... |
|
306 d turbo |
XUD Section
|
1 |
1,719 |
27-03-2013, 09:13 PM |
|
|
Thread: Manual Boost controller
Post: Manual Boost controller
Turned up fueling.Looking to turn up boost now using a manual boost controller,
Is anyone running one,and which controller is best to use?
I have seen this one but not too sure if its any good:
... |
|
306 d turbo |
XUD Section
|
10 |
3,878 |
25-03-2013, 02:30 PM |
|
|
Thread: 306 DT to GTI Brake conversion
Post: RE: 306 DT to GTI Brake conversion
So when they are underneath they act as springs effectively?
do they then push on to carrier so the pads are under a bit of load? |
|
306 d turbo |
Suspension, Transmission, Handling & Braking
|
4 |
1,780 |
16-02-2013, 09:08 PM |
|
|
Thread: 306 DT to GTI Brake conversion
Post: 306 DT to GTI Brake conversion
Not too sure how to fit Pads into the GTI calipers?
Could Someone post a photo,showing top of calipers showing if the spring pins on top of the pads protrude through the top of the caliper or stay ... |
|
306 d turbo |
Suspension, Transmission, Handling & Braking
|
4 |
1,780 |
16-02-2013, 08:44 PM |
|
|
Thread: 306 armrest
Post: RE: 306 armrest
Niall Wrote: (04-02-2013, 07:10 PM)
--
Correct ^ i had to space it up a bit (you can just see it in that photo) but i am a lanky bastard.
--
How did u secure it to the centre console and whats the ... |
|
306 d turbo |
Interior, Exterior, ICE
|
33 |
12,735 |
04-02-2013, 07:12 PM |
|
|
Thread: 306 armrest
Post: RE: 306 armrest
Niall Wrote: (28-01-2013, 09:34 PM)
--
http://i290.photobucket.com/albums/ll257/niallharper/77327217-FDF6-445C-B7A0-FEEFAD2610F4-530-0000004D9C49AFE6.jpg
Seat Ibiza arm rest. Fits perfectly and is... |
|
306 d turbo |
Interior, Exterior, ICE
|
33 |
12,735 |
04-02-2013, 07:06 PM |
|
|
Thread: 306 GTI pads
Post: RE: 306 GTI pads
Any body used the brembo pads? |
|
306 d turbo |
Suspension, Transmission, Handling & Braking
|
7 |
2,652 |
27-01-2013, 07:12 PM |
|
|
Thread: 306 GTI pads
Post: RE: 306 GTI pads
ok what size pads are used on the GTI 6 calipers? |
|
306 d turbo |
Suspension, Transmission, Handling & Braking
|
7 |
2,652 |
26-01-2013, 01:53 PM |
|
|
Thread: 306 GTI pads
Post: 306 GTI pads
Does anyone know which pads are the correct ones as the brembo website lists 2 for LUCAS GTI 6 calipers:
I have found both of the ones listed on brembo catalogue on ebay but unsure as they are diff... |
|
306 d turbo |
Suspension, Transmission, Handling & Braking
|
7 |
2,652 |
26-01-2013, 02:01 AM |
|
|
Thread: D turbo 247 to 283 GTI setup
Post: D turbo 247 to 283 GTI setup
I'm Changing to the bigger GTI brakes soon.
Rear is on drums and self adjusting mechanism is working well.
Running braided hoses all round.
Is it worth changing to the GTI master cylinder asw... |
|
306 d turbo |
Suspension, Transmission, Handling & Braking
|
11 |
2,918 |
09-01-2013, 08:27 PM |
|
|
Thread: Dash removal to change heater control box!
Post: RE: Dash removal to change heater control box!
Yes this helps but i need the complete dash out.
I was posting to find out the best way to take it out and do the heater matrix
Tips please |
|
306 d turbo |
Interior, Exterior, ICE
|
3 |
1,966 |
30-10-2012, 07:46 PM |
|
|
Thread: Dash removal to change heater control box!
Post: Dash removal to change heater control box!
Any tips on how to remove dash to get to matrix and control box?
Thanks |
|
306 d turbo |
Interior, Exterior, ICE
|
3 |
1,966 |
29-10-2012, 02:34 PM |
|
|
Thread: Coolant loss-No visible leaks!
Post: Coolant loss-No visible leaks!
My 306 is losing about 1 litre of coolant every 100 miles
there is no oil in the water or water in the oil
How can i test if it is headgasket leak? |
|
306 d turbo |
XUD Section
|
3 |
1,398 |
06-10-2012, 03:13 PM |
|
|
Thread: Panel Filter or Induction kit and exhaust system?
Post: RE: Panel Filter or Induction kit and exhaust syst...
gumball3000 Wrote: (10-09-2012, 10:47 AM)
--
I dont think either will make a noticable difference, unless you engine is tuned up?
--
engine is not tuned up.
So panel filter it is then?
What b... |
|
306 d turbo |
XUD Section
|
10 |
2,816 |
10-09-2012, 11:27 AM |
|
|
Thread: Panel Filter or Induction kit and exhaust system?
Post: RE: Panel Filter or Induction kit and exhaust syst...
SRowell Wrote: (10-09-2012, 10:29 AM)
--
well the above said mid box is pretty much straight through so i would have thought the backbox would be the better of the two to remove. Arent the standard a... |
|
306 d turbo |
XUD Section
|
10 |
2,816 |
10-09-2012, 10:39 AM |
|
|
Thread: Panel Filter or Induction kit and exhaust system?
Post: RE: Panel Filter or Induction kit and exhaust syst...
Ricky Wrote: (10-09-2012, 09:01 AM)
--
Get rid of the cat and backbox, keep the midbox as its pretty much straight through and stops it being offensively loud.
--
Mine comes as standard with no cat... |
|
306 d turbo |
XUD Section
|
10 |
2,816 |
10-09-2012, 09:50 AM |
|
|
Thread: Panel Filter or Induction kit and exhaust system?
Post: Panel Filter or Induction kit and exhaust system?
Hi im looking to upgrade the air filter soon and not too sure whether to go for uprated filter or induction kit?
Also i will be changing the exhaust soon to let the exhaust gases flow easier?
No... |
|
306 d turbo |
XUD Section
|
10 |
2,816 |
10-09-2012, 08:49 AM |
|
|
Thread: D turbo losing water
Post: RE: D turbo losing water
No wet footwells.
where does the pipe on the back of the block go to? |
|
306 d turbo |
XUD Section
|
11 |
3,411 |
02-09-2012, 10:04 PM |
|
|
Thread: D turbo losing water
Post: RE: D turbo losing water
no split pipes anywhere-recently had a new rad
Is it worth trying k seal? |
|
306 d turbo |
XUD Section
|
11 |
3,411 |
02-09-2012, 07:19 PM |
|
|
Thread: D turbo losing water
Post: D turbo losing water
my coolant has started dropping in the past few weeks.
there are no leaks visible anywhere.
loses about 1 litre every 120 miles
what could be the cause of this and what can be tried to stop t... |
|
306 d turbo |
XUD Section
|
11 |
3,411 |
02-09-2012, 08:35 AM |
|
|
Thread: Hunter the B-road sigma..
Post: RE: B-road basher
ginge191 Wrote: (17-05-2012, 11:35 PM)
--
And finally the pics...
BEFORE
http://i.imgur.com/x87TG.jpg
DURING
http://i.imgur.com/VTLqc.jpg
AFTER:
http://i.imgur.com/ZNvJp.jpg
http:/... |
|
306 d turbo |
306 Projects
|
310 |
81,155 |
17-08-2012, 12:54 AM |
|
|
Thread: WANTED-Phase 1 Leather steering wheel
Post: WANTED-Phase 1 Leather steering wheel
same as the one in this thread link:
http://306oc.co.uk/forum/thread-3218.html
Thanks |
|
306 d turbo |
Parts
|
0 |
1,369 |
16-08-2012, 06:44 PM |